Home
> CONCRETE
> Molds- Sinks
> Vessel Sink Molds
> TC31-VESSEL-SQR-18"
Click to View Concrete Fabrication Videos and Instruction Guides:
|
|
 |
Concrete Sink Mold, Vessel Square 18"
SKU: TC31-VESSEL-SQR-18"
Retail price: $800.00
Our Price:$395.95
You Save: $404.05 (51%)
|
Product Detail: - The 'Vessel Square' Sink Mold for concrete sink fabrication.
- Two part mold- Inner Square Sink Mold, and Outer Vessel Shell Mold.
- Small style drain for bathroom/lavatory size drains.
- Create a seamless integral concrete sink and counter top using the inner mold only, or use both inner and outer molds to create a stand-alone vessel sink.
- Reusable- Durable fiberglass construction allows reusing the mold time and time again. (Unlimited with proper care)
- Easily pays for itself with just one use.
- Sink molds have nice clean edges and surfaces.
- Each mold comes with handles on the inside of the mold to aid in pulling the mold out of the concrete.
Product Specifications: - Sink Mold Measurements: Inner- 15"L x 15"W x 8"D**. Outer- 18"L x 18"W x 9 1/2"D**.
**NOTE: Depth can be adjusted by trimming/sanding down the fiberglass mold to your desired size. - Proper slope (5 degree draft or greater) on sides ensures proper draining and mold removal from concrete.
- Use of wax and a release agent on the mold prior to pouring concrete will make removal easier.
Mold Setup: - Apply a few coats of a strong wax, such as a carnauba based wax, the the molds prior to pouring concrete. We also sell a release agent that is safe for fiberglass, and does not leave an oily residue on the finished concrete.
- This two part mold is designed to simply be siliconed in place. Silicone the inner bowl to a form (melamine, glass, etc.). Place outer Vessel Mold over the inner mold, and silicone the outer mold in place. Pour concrete through hole in the top of the outer shell, vibrating to remove air bubbles as you go. When concrete has cured, remove any cement that has seeped under the outer shell by lightly sanding off with fine sandpaper.
Mold Removal: - WAX and RELEASE AGENT!! Using wax and a release prior to pouring concrete will usually will allow the mold to just be pulled out using the handles.
- In some cases, adding cold water and ice to the inside of the mold for 10 minutes will shrink the mold just enough that removal is easier.
- Using compressed air through the drain hole, or around the sink edges is a very quick and painless way to release the mold (be careful as a high PSI air stream can damage freshly poured concrete).
- In extremely difficult to remove cases, the mold can be pushed out of the concrete through the hole made for the drain.
Mold Care: - Clean with a sponge after each use. Any damage can be repaired using epoxy or gelcoat, and sand smooth when dry.
Shipping Information:
- This product usually ships within 2 business days.
Sample Photos:
|
|
Try These Related Products:
|
Shopping Cart | Check Out
Countertop Products
Molds - Sinks
Molds - Drainboards
Molds - Bath Tubs
Edge Form Liners
Concrete Stamps
Stencil Patterns
GFRC | Mixes
Sealers | Coatings
Stains | Color | Release
Polishing Pads | Diamond Grinding
Vibrators | Tables
Snow Melt Systems
Concrete Sinks
